Elements Desired
24" 18-gauge sterling silver wire
Pre-designed sterling silver cuff bracelet
(You can also make your very own cuff bracelet from major
gauge sterling silver rectangle wire if you prefer.)
Equipment Wanted
Liver of sulfur or oxidizing Answer
Ruler
Marker
Round nose pliers Wire cutters or tin snips File
Chain nose pliers High-quality metal wool Sprucing fabric Protection glasses
1. Apply liver of sulfur or oxidizing Resolution to your 24" of eighteen-gauge sterling silver wire.
It is critical to follow any protection recommendations the manufacturer indicates about the directions when working with any chemical compounds. You might utilize the fine steel wool within the oxidized wire to remove a number of the darkened parts When you finish the wrapping system.
two.Utilize the ruler to evaluate and mark the 24" of eighteen-gauge wire into four sections. Evaluate and mark the wire at 7", 12*. and seventeen".
three.Future, evaluate and mark the center of the very best in the cuff bracelet (because it’s curved, you are able to just type of eyeball it). Then use the ruler to measure and mark %" from the middle of your cuff to either side.
4.Firmly grasp the marked Centre of your 24" eighteen-gauge wire within the jaws from the round nose pliers. Use your fingers to bend the edges right down to variety an upside-down U form (the wire will resemble a considerable bobby pin).
When dealing with very long items of wire, security Eyeglasses are proposed.
5.Slide the wire on to the sterling silver cuff bracelet μονόπετÏα to the middle mark. Pinch the wire restricted onto the cuff bracelet and, while Keeping the wire over the cuff using your fingers, wrap 1 facet with the wire randomly towards the Vi' mark that you just created on the top ασημÎνια κοσμήματα of your cuff bracelet. You'll want to watch where by the 7" and the 17' marks are on the wire and make use of them to match up Using the Vi" mark that you designed around the cuff bracelet.
8. Utilize the round nose pliers to curl the finishes of the wire up to the wrapped wire around the underside on the cuff bracelet. Utilize the chain nose pliers to firmly squeeze the ends up into one other wrapped wire. This will likely maintain the ends securely set up.
6.End wrapping the wire on one other side, matching up the seven" and also the 17" marks over the cuff bracelet Using the Vi" marks to the eighteen-gauge wire.
seven.Now wrap the wire on a single aspect again toward the center on the cuff bracelet. Then wrap the wire on one other side on the cuff bracelet back again towards the middle. You might need to trim and file the ends with the wire δαχτυλίδια μπÏιγιάν so they finish up within the backside on the cuff bracelet.
nine. Use wonderful metal wool to remove the darkened location about the floor of your wire, leaving the areas inside the crevices with the wrapped wire darkish. Buff the wrapped wire as well as cuff bracelet with a polishing cloth.
What tips would you give a commencing artist?
Λ portrait Trainer at the time told μονόπετÏα σχÎδια me that with the 500th portrait I can be seriously good. Lesson-practice; observe everyday.
Stick with one medium and do it rather well. Craftsmanship is essential.
This cuff is perfect for Adult males and ασημÎνια κοσμήματα women. Use the bigger Males's size of pre-made cuff bracelet and add extra length on the eighteen-gauge sterling silver wire, generally 6 to 8 inches to support
the much larger Adult men’s cuff bracelet.
